DW200-1600 Heavy Duty Woven Press Felt Weaving

A kind of superwide heavy loom developed for weaving papermaking felt on the basis of our national conditions is especially suitable for weaving of high-strength cropping papermaking felt, in particular to annular bottom fabric.
Technical Parameters: 
1.Applicable polyester monofilament: 0.10-0.5mm or 0.2mmx6 strands
2.Weft density range: 50-360 weft /10cm.Warp density range: 60-180 weft /10cm.
3.Denting breadth∶16m.
4.Economic speed∶25 rev/min
5.Total motor power∶40.75KW.
6.Machine weight∶about 80T.
7.Overall dimensions∶Width23520×Depth6485×Height2600(mm).
Machine structure:   
1.Rack: Main wall panels in cast iron box type structure to combine the whole machine, in a gap 1780mm
between two sets.
2.Main driving: Dual-motor double-side coaxial drive, 11kw for each motor; dual pneumatic clutch,
elliptical gear transmission for main transmission case.
3.Weft Insertion: Hydraulic shooting-in, 2*2 shuttle box change or weft section mechanism at two sides.
4.Shedding: Large blade type side pull dobby at two sides, 16-pcs heald frame.
5.Beating-up: Multi-section assembled crankshaft four-bar linkage for beating-up at variable speed, a set
of cradle mechanism outside. 
6.Take-up: Three-roller active take-up under electronic control, with upper roll and lower roller driven by
servomotor.
7.Temple mechanism: Ring temple plus side weft control device, ring weaving temple plus side weft
control device. 
8.Warp let-off: Active let-off (by single warp beams, or beaming in reels) under electronic control.
9.Winding: External surface take-up driven by independent torque motor.
10.Lubrication System: Combined automatic or manual feed of grease lubrication.
11.Control system: Computer control system is available for free setting of parameters and automatic
display of faults.