Various types of electromagnetic stirring alloy holding furnace

                 To adopt advanced technology of electromagnetic stirring and the perfect combination of holding furnace, apply to non-ferrous metal aluminum, zinc, magnesium, heat preservation and alloy processing.              1. Heating wire layout in ceramic radiant panel, no direct contact with aluminum liquid vapor, heating element service life is long.              2. High degree of civilized production holding furnace itself no exothermic phenomenon, waste gas and noise              3. Smart, compact structure, cover an area of an area small.             4. With special thermocouple measurement to aluminum water temperature, direct measurement aluminum liquid temperature, assure the temperatures of liquid aluminum real, and reliable.              5. With the intelligent temperature control table, adopt fuzzy PID control technology, temperature control precision is achieved ±1°C.              6.The electromagnetic stirring and liquid with no physical contact, do not pollute the liquid aluminum.              7. It can effectively solve the problem of uniformity of alloy composition.              8.Does not destroy oxide layer mixing, thus can reduce the oxidation slag, to reduce the burning loss rate.              9.Stirring direction and stirring intensity can be adjusted.             10. A one-time investment, the cost is low, save energy, enhance productivity.                        Matters need attention                 1. The repair and maintenance of the equipment shall be composed of professional and technical personnel operation.                 2 Without the manufacturers allow devices shall not change the circuit and equipment (Can replace the same specifications of the device)                3 The person has the electronic or metallic implants (such as a pacemaker or metal connector in the spine) during the equipment operation are strictly forbidden to close to the electromagnetic stirrer sensors.              4 Keep the equipment clean, do not put sundry.              5 Operation should be performed according to the operating instructions of the equipment.                  Quality assurance commitment               The whole equipment warranty for one year, in the warranty period all equipment failure caused by the product quality, we will unconditionally solutions within 48 hours or sent to the scene to solve. If due to improper use or accident situation of equipment failure, we should solve immediately, but the buyer need to bear the cost.                   Can greatly shorten the melting time               Electromagnetic stirring needn't open the oven door, reduce the heat loss, improved the burner combustion power. Shorten the heating time and the melting time, reduce the oxide slag formation, greatly improve the efficiency of the furnace. A large number of application data shows, as a general rule, electromagnetic stirring can shorten the melting time is more than 20% about no electromagnetic stirring, can reduce the 10%~15% fuel consumption, can improve 15%~30% productivity.              Because of the electromagnetic stirring, can in a short time under the condition of liquid and meet the process requirements, and stir fully, can significantly reduce molten metal drops in the slag layer in the package, shortening the time of liquid exposed to the air, so as to improve the recovery efficiency of metal, the decrease of slag roughly in about 15% ~ 30%.            Greatly shorten the temperature and composition of the uniform time, and improve overall uniformity.